Water report · not indexed
What is in the water at 25003
2 public water systems serve this ZIP code in the federal records. Everything below comes from EPA monitoring data, and everything missing is named.
WVAWC-KANAWHA VALLEY DIST
PWSID WV3302016 · WV · serves 207,319 people
PFAS and lithium
Sampled, nothing detected. Tested for 30 compounds under UCMR 5 with none found at or above its reporting limit. A reporting limit is the lowest concentration the method can measure, so this means “below that” rather than “zero”.
Health-based violations
No open health-based violation on record. This covers MCL, treatment technique and MRDL violations in SDWIS that have not been returned to compliance. It excludes monitoring and reporting violations, which are the large majority nationally, so this is not “no violations”, and SDWIS completeness varies by state.
Hardness
Median hardness 104 mg/L as CaCO₃, measured at 11 stations serving this system across 11 results, 2017-06-12 to 2017-07-19. Measured in the water source and distribution area, not at a tap, and not in your home.
LINCOLN PSD
PWSID WV3302205 · WV · serves 4,039 people
PFAS and lithium
1 compound detected at or above the reporting limit under EPA’s UCMR 5 monitoring, across 4 samples.
| Compound | Highest detected | Samples | Most recent |
|---|---|---|---|
| lithium | 65 µg/L | 4 | 7/22/2025 |
A detection is a measurement, not a violation and not a health finding. EPA states that UCMR 5 results do not indicate compliance or non-compliance with any limit.
Health-based violations
13 open health-based violation(s) recorded in SDWIS and not yet returned to compliance.
- TT · contaminant code 2920 · began 2018-07-01
- TT · contaminant code 2920 · began 2018-10-01
- TT · contaminant code 0800 · began 2023-08-01
- TT · contaminant code 0800 · began 2023-08-01
- TT · contaminant code 5000 · began 2025-10-01
- TT · contaminant code 0300 · began 2025-11-01
- TT · contaminant code 0300 · began 2025-12-01
- TT · contaminant code 0300 · began 2025-12-01
Hardness
No hardness measurement. Hardness is measured at environmental monitoring stations, and none fell inside this system’s service area. That is a gap in where monitoring happens, not a finding about the water.
What this report cannot tell you
Every figure describes water at a sampling point: a treatment plant, an entry point to the distribution system, or a monitoring station. None of it describes water arriving at your tap. Plumbing between the two can add lead and copper, and if your home was built before 1986 a test kit tells you something no federal dataset can.
Sources: EPA UCMR 5 occurrence (final release, frozen July 2026) · EPA SDWIS health-based violations · USGS and state monitoring via the Water Quality Portal · EPA Public Water System Service Area Boundaries v3. Compiled 2026-09-01.